To Next Page

To Previous Page

Instruction Manual | 11

Setting the time

When the appliance is plugged into the electrical mains supply, or when

power is restored after a power cut, the digital display will ﬂash 0.00.

• Touch and hold (or simultaneously touch / ) until is shown

on the display and the dot below the symbol is ﬂashing

• Touch / within 7 seconds to set the current time.

• Use the / sensors to set the Kitchen Timer. The display will show the

set time and Kitchen Timer symbol .

Once the set time elapses, alarm will sound and the icon will ﬂash.

• Touch and hold or simultaneously touch and hold / to mute

the alarm, the will be o and the display will show the current time.

Note:

If no button is touched, the alarm will turn off automatically

after approximately 7 minutes.

To store the new time setting, wait approximately 7 seconds after the time

has been set. The dot below the symbol will stop ﬂashing. You can

adjust the time later. T

o do this touch / simultaneously and adjust the

current time while the dot below the symbol is ﬂashing.

Note:

The oven can be operated only when you see the symbol is

shown.

You can activate the Kitchen Timer at any time, regardless of the status of

other functions. The Kitchen Timer can be set from 1 minute up to 23 hours

and 59 minutes.

To set the Kitchen Timer:

• T

ouch , then the display will show blinking

CDA SC035 User Manual

Questions and Answers: