CDA SC212 User Manual

10
Installation
Important
If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not installed as
it could restrict ventilation.
Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclosed built-under oven
housing unit it may be necessary to cut a small slot in the top of the plinth fitted under the unit. Cut a section 400mm wide and a
minimum of 15mm high to allow air to pass under the unit. Alternatively cut a section 400 x450mm in the base of the carcass as
indicated.
Failure to allow adequate ventilation to the appliance may result in overheating or damage to adjacent units and could invalidate
the warranty.
This appliance is type X installation.
The walls of the kitchen units must be able to withstand temperatures of 75˚C above ambient (typically this is between 90˚C
and 100˚C).
When correctly installed ensure that there is a gap of 4mm minimum between the sides of the oven and adjacent
furniture doors.
Lift the oven carefully into position on the shelf, taking care NOT to lift it by the door handle. If you lower the oven door, you will
see 4 screw holes, 2 on each side of the oven. The oven should then be secured to the housing by fitting screws into these holes.
Remember the housing should not be free standing but be secured to the wall and/or adjacent fittings.
How to install your oven
You will need the following housing area fit your oven correctly.
The oven is designed to fit into a cabinet of
600mm width. The oven can be built in or built
under the kitchen units, but you must ensure
that it is properly ventilated. In the diagram the
built-in oven is ventilated by means of a space at
the top of the kitchen cabinet. There are many
other methods of ventilating your oven - consult a
qualified engineer for advice.
fig. 3
40
560
600
600
560
595
595
595
542
554
24 (22 BL/WH)
Dimensions Oven Housing
Height (mm) 595 600
Width (mm) 595 560
Depth (mm) 563.5 560 (min)
600
560
595
595
595
554
24 (22 BL/WH)
542
= airow

CDA SC212 Specifications

General

Grill	Yes
Oven size	Medium
Oven type	Electric
Number of ovens	1
Total oven power	2160 W
Number of shelf positions	2
Total oven(s) interior capacity	56 L
Noise level	- dB
Control type	Rotary
Product color	Stainless steel
Built-in display	-
Control position	Front
Appliance placement	Built-in
Current	13 A
AC input voltage	230 V
AC input frequency	50 Hz
Energy consumption (conventional)	- kWh

Weight and Dimensions

Depth	537 mm
Width	595 mm
Weight	30000 g
Installation compartment depth	560 mm
Installation compartment width	564 mm
Installation compartment height	600 mm