7
fig. 1
1
2
3
4
5 6 7
1 Cooking time indicator
2 End of cooking time indicator
3 Minute minder indicator
4 Current time indicator
5 Decrease key
6 Mode key
7 Increase key
Programming the oven
Please note:
• The alert beep will cut off after two minutes if it is not switched off
manually.
Setting the clock
The clock is preset to 12:00, and will revert to this after a power failure.
When the current time indicator is flashing, touch
or . When the
correct time is shown on the display, the clock will set after approximately
five seconds’ delay.
To change the clock once it has been set, touch
repeatedly until the
current time indicator flashes, then touch
or . When the correct time
is shown on the display, the clock will set after approximately five seconds’
delay.
The minute minder
The minute minder can be used when the oven is switched on or off. It can
be set for up to 23 hours and 59 minutes.
To set the minute minder:
• Touch
repeatedly until the minute minder indicator flashes.
• Then touch
or to select the required duration for the minute
minder. When the correct duration shows on the display, either touch
or wait for approximately five seconds. The minute minder indicator will
remain lit to confirm the minder minder is on.
• When the countdown is complete, there will be an alert beep which will
continue for two minutes and the minute minder indicator will flash. To
switch off the alert beep, touch any key.
Please note:
At the end of the countdown, the minute minder will not switch off the
oven. Remember to turn off the oven manually.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
