Cebora MIG Weld 333 S

Questions and Answers

S
Shannon CunninghamAug 10, 2025
Why is my Cebora Welding System producing a lot of metal spatter?
- G
  greenloriAug 10, 2025
  If your Cebora Welding System produces welding with a lot of metal spatter, it might be due to incorrect welding parameter settings. Ensure you've selected the appropriate parameters using the welding-voltage switch and wire-speed adjustment potentiometer. Also, check the grounding connections to ensure they are sufficient. An uncorrect sheath diameter can cause wire advancing improperly.
K
Karen SchultzAug 18, 2025
What to do if the wire is not advancing in my Cebora Welding System?
- M
  Mary LaraAug 18, 2025
  If the wire is not advancing or advancing improperly in your Cebora Welding System, consider these potential causes: the wire roller may have too wide of a groove, so replace the roller. The liner might be obstructed or clogged, so extract and clean it. The wire pressing roller may be loose, so tighten it. The coil reel friction might be too tight, so loosen and adjust it. Also, the current nozzle might be clogged, so replace it.
V
Victor CalhounAug 25, 2025
What to do if the wire jams in my Cebora Welding System?
- D
  Dr. Ralph CrossAug 26, 2025
  If the wire jams or entangles between the drive rolls and the torch infeed of your Cebora Welding System, it could be due to several reasons. Check if the current nozzle diameter is correct and replace it if it is wrong. Ensure the roller groove alignment is correct, and align it if it's not. Also, inspect the sheath for obstructions or clogs; remove and clean it if necessary.
J
Jordan MillerSep 1, 2025
How to troubleshoot limited electric output on Cebora Welding System?
- K
  Kenneth OwensSep 1, 2025
  Limited electric output in your Cebora Welding System can stem from several causes. First, check the phase of the feed line and/or the remove control switch contacts, as a phase may be missing. Also, a line fuse may be burnt, so replace it. Ensure the connections on the voltage changer terminal board are correct by following the plate scheme. The rectifier diode may be burnt, so replace the rectifier. Tighten all connections, as the torch or ground connections may be loosened. The welding regulation commutator may have an uncertain contact, so replace the commutator. Finally, if the trasformer wire is interrupted on the commutator, unscrew the commutator contact, remove the wire insulation and put it under the contact.