Cebora MIG User Manual

1/30
19/01/2021
3301162
IT MANUALE DI ISTRUZIONI PER SALDATRICE A FILO - ISTRUZIONI IN LINGUA ORIGINALE pag. 2
Parti di ricambio e schemi elettrici / vedi Allegato
EN INSTRUCTION MANUAL FOR WIRE WELDING MACHINE - Translation of the original instructions pag. 31
Spare parts and wiring diagrams / see Annex

Cebora MIG Specifications

General

Brand	Cebora
Model	MIG
Category	Welding System
Language	English

Summary

General Safety and Operational Guidelines

Manual and Expert Usage

Emphasizes careful manual reading and the need for expert staff for operation and maintenance.

Liability and Improper Use

Understanding Safety Symbols

Symbol Definitions

Defines DANGER, WARNING, CAUTION, NOTICE, and INSTRUCTION symbols used throughout the manual.

Warning Plate Interpretation

Explains specific pictograms and warnings found on the equipment's warning plate.

Installation and Start-up Safety Procedures

Qualified Personnel and Transport Safety

Stresses installation by qualified staff and safe transport/lifting practices.

Mains Connection and Earthing

Crucial safety steps for connecting to mains power and ensuring proper earthing.

Gas Cylinder Handling and Wire Feed Setup

Gas Cylinder Safety Precautions

Safe handling of gas cylinders and regulators, including securing them properly.

Front Panel Controls and Interface

Display and Knob Operation

Explains the main display and the knob for parameter adjustment.

Key Connectors and Sockets

Rear Panel Connections and Controls

Power and Gas Connections

Touch Screen Display Functionality

MIG Process Main Screen

Overview of displayed welding parameters and job status.

Pre-Weld Tests

Welding Start Modes (2T, 4T, 3L)

Selection of welding start/stop modes and related parameters like HSA/CRA.

MIG Process Parameter Configuration

Process Parameters Menu Access

Navigating to the process parameters menu for adjustments.

Start Current and Time Settings

Adjusting start current, connection time, and crater filling parameters.

Mode 4T and 3L Specifics

Advanced MIG Welding Controls

Torch Trigger Mode Settings

Configuring 2T, 4T, and 3L modes for torch trigger operation.

Spot and Pause Time Adjustments

HSA and CRA Function Setup

Configuring Automatic Hot Start (HSA) and Final Crater Filling (CRA).

Arc Length and Inductance Tuning

Adjusting arc length correction and inductance for weld quality.

MIG Process Selection and Arc Control

Welding Process Type Selection

Choosing between MIG Pulse, MIG Short, and MIG Manual processes.

Material and Gas Configuration

Selecting wire type, diameter, and welding gas.

Arc Length and Inductance Fine-Tuning

Detailed adjustment of arc length and inductance for optimal welding.

MIG Torch and Special Feature Settings

Torch Trigger Operation Modes

Spot and Pause Time Configuration

HSA and CRA Parameter Setup

MIG Weld Start and Arc Dynamics

Soft Start Configuration

Burnback Correction Adjustment

Bi-level Welding Setup

MIG Weld Arc and Gas Flow Control

Bi-level Frequency and Speed

Arc Correction and Preflow/Postflow

Accessory Settings and Machine Configuration

Push-Pull Torch Force Adjustment

Machine Settings Menu Navigation

Machine Configuration Options

Factory Setup and Resetting Modes

Job Programs and MMA Process Introduction

Job Program Management

MMA Process Overview

MMA Process Parameter Settings

Hot Start Functionality

Hot Start Time Adjustment

MMA Weld Characteristics and MIG-MAG Setup

Arc Force and Antistick

MIG-MAG Connection and Process Selection

MIG Welding Types and Error Handling

MIG Pulse, Short, and Manual Welding

Error Code Classification

Troubleshooting: Error and Alarm Codes

Hardware Error Code Reference

List of hardware error codes, their descriptions, and required actions.

Alarm Code Reference

List of alarm codes, their descriptions, and required actions for user intervention.