Cebora MIG - MIG Process Selection and Arc Control; Welding Process Type Selection; Material and Gas Configuration; Arc Length and Inductance Fine-Tuning

47/60
Process
SELECTING THE WELDING PROCESS, MIG, OR MMA�
After selecting the MIG welding process, with knob 2 you can select the arc transfer type: MIG Pulse, MIG
Short, and MIG Manual.
To conrm the selection press knob 2 or key .
Material
SELECTING WIRE TYPE, DIAMETER AND WELDING GAS�
To conrm the selection press knob 2 or key .
Parameters
SELECTING PROCESS PARAMETERS
• Arc length correction.
Turn knob 2 to select the parameter and conrm the selection by pressing the same knob.
Adjust the value by turning knob 2.
To conrm the selection, press knob 2 or key .
Press the
DEF
key to restore factory settings.
• Inductance correction.
Turn knob 2 to select the parameter and conrm the selection by pressing the knob.
Adjust the value by turning knob 2.
To conrm the selection, press knob 2 or key .
Press the
DEF
key to restore factory settings.