ENGLISH
14 3D FORCEANODIZED 750 SMART
3. BEFORE USE
Note: some parts of the steam iron have been slightly greased and as a result, the iron may
slightly smoke when switched on for the first time. After a short time, this will cease.
1. Take the product out of the box.
2. Remove any packaging materials, stickers or protective foil from the soleplate.
3. Clean the soleplate with a soft cloth.
4. OPERATION
WATER TANK FILLING
1. Unplug the iron before filling the water tank.
2. Rest the iron on its heel rest, tilt forward approximately 45º and pour water into the water-
filling opening up to the MAX mark.
VERTICAL STEAMING
1. Make sure there is enough water in the water tank.
2. Stand the steam iron vertically, rest it on its heel and connect it to the power supply.
3. Turn the temperature and steam knob to maximum.
4. Hold the iron vertically and press the steam burst button, an intense steam will be ejected
from the soleplate.
DRY IRONING
1. Turn the steam knob to the “0” position.
2. Select the appropriate temperature according to the type of fabric.
STEAM IRONING
1. Unplug the de iron and fill the iron with water.
2. Connect the iron to the power supply.
3. Use the + and – buttons to select on the LCD display the type of fabric to be ironed.
4. Set the steam knob to the desired position (eco mode, medium steam or maximum steam).
5. When finished, use the + and – buttons to select OFF on the LCD display and unplug the
device from the power supply.
SAFE START UP WITHOUT HEAT IN THE SOLEPLATE
As a safety measure, when the iron is turned on, the soleplate does not generate heat. Select this
mode also to turn the iron off.
SYNTHETIC-CLOTHES IRONING
• Low-temperature and no-steam operation.
• When this function is selected, the display will show the temperature symbol and a dot
ECO
To Next Page
Loading...
Need help?
General