ENGLISH
37
2. Set the timer.
The day of the week and the time must be set correctly in order for the schedule to operate
properly. Check the before section (Set the current time and day).
• Press the button, the week day and icon will ash on the display.
• Use arrows to select the day of the week which you desire to schedule.
• Use the direction arrow to switch from the day of the week to time. Use the
buttons to select the desired time. Repeat this step to set the minutes: press and then
to select the minutes.
• Press to conrm the selected day’s settings and to move on to the next day’s one.
• If you desire not to schedule one of the days, set the time at 00:00.
• Once the days and times have been set, press to save the settings and exit scheduling.
The robot will emit a beep indicating the schedule has been saved correctly.
Note: the robot’s switch must be set at “I” and the robot must be charged during scheduling to
ensure the robot operates automatically at the correct time.
3. Schedule cancelling
Press on the remote control for 3 seconds. The icon on the display will turn off and the robot will
beep twice, indicating the schedule has been cancelled.
Note: after replacing the remote control
`
s batteries, the current time and the scheduled clea-
ning have to be set again.
05133_Conga 1190 Gyro_Manual_PE.indd 37 1/8/18 12:38
To Next Page
Loading...
