cecotec Conga 1790 Ultra - Cleaning Modes and Functions

39
ENGLISH
carry out scheduled cleaning if it has been scheduled while the switch is ON, otherwise, it will
have to be scheduled again from the remote control or the App.
Cleaning modes
This robot includes different modes and different functions that can be activated from the
remote control or the App.
Auto mode
Press the power button for the robot to start Auto cleaning mode.
The robot will clean the whole surface, edges, around objects such as tables, chairs etc. Once
it starts running out of battery, it will return to the charging base.
Fig. 27
Thorough Scrubbing mode
Attach the mop cloth to the water tank and ll the tank with water.
Take the dust tank out.
Install the water tank in the robot and turn it on.
Fig. 28
Use the remote control to select the desired scrubbing power level: High, Medium or Low.
Once the scrubbing mode is selected from the remote control or the app, the device will
perform the function “All in One” to vacuum, mop, scrub and sweep at the same time thanks
to its mixed tank.
Note: If you want to sweep the oor, skip the water-lling step.
To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
Spiral mode
The robot will carry out an intense cleaning of a specic area when this mode is activated.
The robot will start cleaning at a specic point and will move outwards performing spiral
movements (1 meter). Then, it will return to the starting point in spiral movements again.
Before operating the robot under Spiral cleaning mode, place it on the spot to be cleaned.
Press the spiral cleaning button on the remote control or on the App.
Fig. 29
Edge mode
When this mode is selected, the robot will clean along walls and around furniture (table or
chair legs, for example).
Press the edge cleaning button on the remote control or on the App.
Fig. 30
Room mode