45
The robot cannot be activated Make sure the main power switch is in the ON
position.
Make sure the battery is fully charged.
Replace the batteries (2 AAA) in the remote
control.
Make sure the remote control is within the
robot’s range (16 ft/5 m).
If the problem persists, turn the main power
switch off and restart it.
The remote control does not work Replace the batteries in the remote control.
Make sure the robot is turned on and fully
charged.
The robot stops operating suddenly Check if robot is trapped or stuck on an
obstacle.
Check if the battery level is too low.
If the problem persists, turn the main power
switch off, wait for 2 seconds and restart it.
The schedule function does not work Make sure the main power switch on the
bottom of robot is turned on.
Make sure the time, time of day (AM/PM), and
the scheduled time have
been set correctly.
Check if robot’s battery is too low to start
cleaning.
Weak suction power Check if any obstructions are blocking the
suction inlet.
Empty the dust tank.
Clean the lters with a vacuum cleaner or a
cleaning brush.
Check if the lters are wet.
Air-dry the lters completely before use.
The robot does not charge Check if the indicator on the charging base
are lighted up. If not, contact the Technical
Support Service of Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the
charging base. If not, contact the Technical
Support Service of Cecotec.
To Next Page
Loading...
