cecotec Conga 2290 Ultra T - Operation Features; Additional Cleaning Modes and Features; Setting Cleaning Schedules; Cleaning and Maintenance

CONGA 2290 ULTRA TCONGA 2290 ULTRA T 4948
ENGLISH ENGLISH
will automatically start cleaning the selected days at the desired time.
- The time options on the remote control are: 12:00 a. m.–11:59 p.m. and 12:00 p.m.–11:59 p.m.
- Before setting the time and the robot conguration, make sure the robot’s power switch
is on and that the power button on the robot is lit up.
Conguration with the remote control
- Press the schedule button on the remote control. Digits will start blinking. Fig. 36
- Use direction buttons to select the day. Once selected, use right and left buttons to
select minutes and hours. Use direction buttons when digits are blinking to congure the
desired minutes and hours. Press the power button to save settings. Enter the desired
days and follow the same steps to schedule them. Fig. 37
- Finally, press the schedule button to exit scheduling mode. The robot will beep once
indicating the scheduled cleaning settings have been conrmed.
- The user may schedule as many days per week as desired. The home screen will display
when the robot is scheduled.
- Cancelling scheduled cleaning
- Press the schedule button on the remote control, select the day you wish to delete
and change the set time to 00:00 am., this is the time to be set to cancel the cleaning
programme. Fig. 38
4. CLEANING AND MAINTENANCE
- In order to lengthen your robot’s shelf life and to allow your robot to operate at peak
performance, carry out the following procedures periodically.
- Empty the robot’s dust tank.
- Press the dust tank’s release button. Fig. 39
- Open the dust tank and empty it. Fig. 40
Robot lter cleaning
- Remove the lter.
- Carefully shake o all dust from the lter. Fig. 41
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe o any dust from the free-fall sensor located on the
right side of the robot’s bottom part.
Warning
Do not spray cleaning products directly on the sensor. Fig. 42
Normal and Eco. You can turn the power level function o if you want to use the mixed tank
only to scrub. Fig. 32
Scrubbing intensity function
Press the scrubbing levels button on the remote control or on the App to adjust the water
level during the scrubbing process. There are 3 water levels: High, Medium or Low. You can
turn the power level function o if you want to use the mixed tank only to sweep.
Random mode
- The robot will clean randomly and will smartly return to the charging base when it runs
out of battery. The robot will not create any map under this mode.
- This mode can be selected from the App.
Manual mode
The robot will move manually by using the arrows in the remote control or on the App.
Magnetic strip
Use the magnetic strip included to delimit the cleaning area so the robot is not able to access
to certain areas.
Cleaning scheduling
This robot includes schedule settings in order for you to customize the cleaning cycles. The
robot can only be scheduled through the remote control or through the App.
Note
Make sure the remote control is close to the robot when setting the clock or scheduling
cleaning cycles.
Setting the remote control’s time
- Press the clock button on the remote control. Digits will start blinking.
- Select the current day of the week by pressing the upwards and downwards buttons. Fig.
33
- Use the left and right buttons to set minutes and hour. Use upwards and downwards
buttons to change the digit while it ashes. Fig. 34
- Finally, press the power or the clock button. The robot will beep when the time settings
have been conrmed. Fig. 35
Cleaning scheduling
- For a better and more comfortable cleaning, the robot includes a schedule function to set
daily schedules through the remote control. In accordance to the conguration, the robot