EasyManua.ls Logo

cecotec Conga 2290 Ultra - Page 6

cecotec Conga 2290 Ultra
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- Avoid operating the product under extremely high or low
temperatures.
- Remove the battery from the product’s inside before
scrapping the robot.
- Disconnect the appliance from the power supply before
removing the battery.
- The appliance is not intended to be used by children under
the age of 8. It can be used by children over the age of 8, as
long as they are given continuous supervision.
- This appliance can be used by children aged 8 and above,
and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, as long as
they have been given supervision or instruction concerning
the use of the appliance in a safe way and understand the
hazards involved.
- Children should be supervised that they do not play with
the appliance. Close supervision is necessary when the
appliance is being used by or near children.
Battery instructions
- This appliance includes Li-ion batteries, do not incinerate
or expose them to high temperatures, as they may explode.
- Leaks from the battery or battery cells can occur under
extreme conditions. Do not touch any liquid that leaks from
the battery. If the liquid gets into contact with skin, wash
immediately with soap and water. If the liquid gets into
the eyes, ush them immediately with clean water for a
minimum of 10 minutes and seek medical attention. Wear
gloves to handle the battery and dispose of immediately in
accordance with local regulations.
- Avoid contact between the battery and small metallic
objects such as paper clips, coins, keys, nails or screws.
In case of malfunction, please send the product to our
Customer Service.
Robot instructions
- This product must be used in accordance with the directions
in this instruction manual. Cecotec cannot be held liable or
responsible for any damages or injuries caused by improper
use.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is grounded.
- This product can only be disassembled by qualied
personnel.
- Do not touch wires, power supplies or power adapters with
wet hands.
- Keep the robot away from clothing, curtains and any other
similar materials.
- Do not expose the robot to direct sun, open re or wet
environments.
- Do not sit or place heavy or sharp objects on top of the
appliance.
- This product is designed for indoor use only, do not use
outdoors.
- Before operating the robot, remove all objects and wires
that could aect its operating.
- Always place the device on a at and stable surface. Avoid
placing it in unstable places where there is risk of falling,
such as tables or chairs.
- Turn o the power switch, located on the bottom part of the
robot, when it is not going to be used for a long time.
- Before operating it, make sure all the robot’s and charging
base’s connections are in good conditions.

Related product manuals