CONGA 3000 CARPETCLEAN
31
ENGLISH
5. Stop spraying clean water and vacuum the waste water (Fig. 12). After using the device,
dry the surface with a dryer or let it air dry.
6.
7. Disconnect the device from the power supply.
8. Empty the clean and waste water from the tanks and clean the waste-water tank.
Warning
- Do not spray water continuously over the same spot.
- Take special care when using the device to clean stairs.
- After using the device, hang and wind the power cord in the power cord holder.
Cleaning embedded dirt
Warning:
- You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
- Make sure the detergent will not damage the soiled surface before using it.
- Do not use thinners, aniline, chloroform or flammable detergents.
Recommended liquids
- Alkaline ionised water.
- Low-foam detergent to the clean water tank combined with water in a 5:10 proportion.
- Citric acid
- Water with hydrochloric acid.
Non-recommended liquids
- Neutral kitchen detergent.
- Alkaline detergent.
- Acid detergent.
1. Apply detergent over the soiled surface, spray clean water and scrub the dirt with a brush
(19) to bring it to the surface.
2. Vacuum the dirt and do not let any detergent remain. Fig. 14
Warning:
- To know the detergent quantity and use, carefully read the manufacturer instructions.
- Stop using the device when the water or foam in the waste-water tank (12) reaches the
maximum water level and clean the waste-water tank (12); otherwise, water may enter
the machine.
Using the right-angle suction nozzle
Press the suction nozzle against the soiled surface and move it from top to bottom. Fig. 15
To Next Page
Loading...
