cecotec CONGA 3690 - 8. BATTERY REPLACEMENT AND CHARGING; HIGH-EFFICIENCY FILTER; SIDE BRUSH; FREE-FALL SENSORS

ENGLISH
37
3. Use the cleaning brush to clean the inner part of the tank
and reinstall the high-efciency lter.
4. Introduce the dust tank back into the robot and close the
top cover.
HIGH-EFFICIENCY FILTER
Remove the high-efciency lter and shake it to remove all the dust.
Note:
• Replace the high-efciency lter every 3 months (depending on the
frequency and type of use).
• Clean the lter periodically with a brush to avoid blockage.
• Wash the lter with water and dry it thoroughly before
reassembling it. Do not use detergents.
SIDE BRUSH
Remove and clean the side brushes regularly.
Note: in order to ensure a perfect cleaning, it is suggested to replace the
side brushes every 3 months.
FREE-FALL SENSORS
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its
original package.
8. BATTERY REPLACEMENT AND CHARGING
• Do not use any other battery, power adapter or charging base than the one provided
ofcially by Cecotec.
• Do not use non-rechargeable batteries.
• Do not remove, dismantle or attempt to repair the battery or the charging base.
• Do not place the charging base near heat sources.
• Do not use a wet cloth to wipe any of the parts of this product.
• If the robot is not going to be used for a long time, remove the battery from the product
and store it in a dry and safe place. It is suggested to charge the battery every month in
order to avoid damage to the battery.
4