28 | CONGA 3890
ENGELSK
Recommendations:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
If there are carpets in the house, set Restricted Areas to avoid the robot
from passing over them.
Add some drops of cleaning agent (not corrosive) if considered necessary.
To remove the mop bracket, press the release button and pull from it
outwards.
Warnings:
Using cleaning agents in excess might block water outlets.
In order to achieve perfect scrubbing, it is suggested to moisten the mop
before using it.
First cleaning
Once the robot and the charging base are completely installed, follow these
steps before scheduling the rst cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the
robot to charge overnight. When it is fully charged, it may carry out the
rst cleaning cycle and save the rst map. To do so, activate Auto cleaning
mode and Eco power level. It is very important to follow these indications
for the robot to recognize each and every corner in the house and to create
a complete map.
If the house where the robot is going to be used is too big and the robot runs
out of battery, do not worry. The robot features TotalSurface 2.0 technology,
so when it returns to the charging base, it saves the full map and those that
have not been completed. Once it is charged again, it resumes the cleaning
cycle from the point it has stopped until it maps the whole surface. The
robot keeps on mapping constantly, therefore it adapts independently to
each house’s features and continuously improves previous maps
4. OPERATION
Once the robot’s light indicator changes from oscillating orange to steady
blue, the battery is fully charged and the robot is ready to operate.
The robot cannot operate with low battery.
Recommendations: Remove all cables and obstacles from the oor before
operating the robot in order to avoid accidents and damage.
5.1. Robot buttons
Fig. 12.
To Next Page
Loading...
