cecotec CONGA 3890 - Side Brush and Sensor Cleaning; Battery Replacement and Charging; Troubleshooting

CONGA 3890 | 37
ENGELSK
Side brush
Fig. 30.
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to
replace the side brushes every 3 months, depending on the frequency and
type of use.
Free-fall sensors
Fig. 31.
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned o and in its original package.
7. BATTERY REPLACEMENT AND CHARGING
Do not use any other battery, power adapter or charging base than the one
ocially provided by Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging
base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from
the product and store it in a dry and safe place. It is suggested to charge the
battery every month in order to avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over
to professional organizations for correct treatment.
8. TROUBLESHOOTING
Problem
1. The robot does not start up or does not clean.
2. The robot cannot charge or return to the charging base.
3. The robot does not work properly.
4. The robot emits a strange noise during cleaning.
5. The robot does not clean eciently or dust leaks from the robot.
6. The robot could not connect to Wi-Fi.
7. The robot did not carry out the scheduled cleaning task.
8. The robot does not return to the charging base after spot cleaning or
after changing starting position.
9. The robot does not resume cleaning.