cecotec CONGA 3890 - Brush Cleaning; Dust Tank and Filter Maintenance

36 | CONGA 3890
ENGELSK
Recommendation: Replace the main brush every 6-12 months to ensure
ecient operating (depending on the frequency and type of use).
Fig. 24.
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
Silicone brush
Fig. 25.
To clean the silicone brush, follow the instructions on the previous section to
remove it from the robot and wash it with water and soap. Dry it thoroughly
before assembling it back in order to ensure ecient operation.
Jalisco brush
To clean the Jalisco brush, follow the previous section’s steps to take it out
and clean it with water.
Dry it thoroughly before assembling it back in order to ensure ecient
operation.
Dust tank
Open the robot’s cover and take out the dust tank.
Open the dust tank, take the high eciency lter out and empty the dust.
Fig. 26.
Use a cleaning brush to clean the tank’s inner part and reinstall the high-
eciency lter.
Fig. 27.
Introduce the dust tank back into the robot and close the top cover.
Fig. 28.
High-eciency lter
Fig. 29.
Remove the high-eciency lter and shake it to remove all the dust.
Recommendations:
Replace the high eciency lter every 3 months depending on the frequency
and type of use.
Clean the lter periodically with a brush to avoid blockage.
Do no wash the lter with water.