ENGLISH
31
WET & DRY TANK INSTALLATION
Note: it is not suggested to use the scrubbing function for the rst-time use.
1. Open the tank’s rubber lid, ll the tank with water carefully so water does not come
out. Make sure the silicone clip is properly closed to avoid water from spilling.
2. Install the tank in the robot following the directions indicated in the drawing. Make
sure the clip is properly fastened.
3. Only for Wet & dry tank installation:
Attach the mop to the bottom part of the mop bracket with the Velcro.
4. Manually press the clips on both sides of the mop bracket and push it into its correct
position until you hear a click indicating it is properly xed.
To Next Page
Loading...
