cecotec CONGA 4090 - Cleaning and Maintenance Procedures; Main Brush Maintenance

ENGLISH
39
• Create an account with your e-mail and a password.
• Conrm login.
• Add your Conga robot.
• Connect to Wi-Fi.
WARNINGS:
• The Wi-Fi name and password cannot exceed 32 bits.
• If the network conguration fails to connect, follow the below steps:
- Press the start button for 5 seconds, the robot will enter sleeping mode and the Wi-Fi
light indicator will blink fast indicating connection error. Retry connecting the robot again
following the steps in the before section.
- If the connection fails again, check if:
a. The robot is too far away from the router.
b. The Wi-Fi password is incorrect.
7. CLEANING AND MAINTENANCE
MAIN BRUSH
1. Turn the robot around and press the main brush’s release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover’s clip.
Note: replace the main brush every 6-12 months to ensure efcient operating (depending on
the frequency and type of use).
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
1
2
3
4