cecotec Conga 5290 Ultra - Cleaning and Maintenance; Component Cleaning Procedures

40
ENGLISH
6. CLEANING AND MAINTENANCE
Jalisco main brush
− Turn the robot around and press the main brush’s release button to take the cover out.
− Take the main brush out and clean the compartment.
− Clean the main brush with the provided tools and use water and soap if necessary. Dry it
carefully before installing it again. The brush must be completely dry before installing it, as
any remaining moisture can reach the motor and damage it. Fig. 9-10.
− Place the main brush in its position and fasten the cover clip.
Recommendation
Replace the main brush every 6-12 months to ensure ecient operating (depending on the
frequency and type of use).
Wet & dry tank
Fig. 11.
− Remove the solids tank.
− Open the tank cover and empty it.
− Remove the lter and lter holder as shown in the image.
− Use the cleaning brush to clean the inside of the solids tank.
− You can clean the dust compartment with water, without immersing the tank.
− Install the dust tank back in the robot.
High-eciency lter
Fig. 12.
Remove the high-eciency lter and shake it to remove all the dust.
Note:
− Replace the high-eciency lter every 3 months depending on the frequency and type of
use.
− Clean the lter periodically with a brush to avoid blockage. Do not use water or detergents.
Side brush
Fig. 13.
Remove it with a torx screwdriver and clean the side brushes regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months, depending on the frequency and type of use.
Free-fall sensors
Fig. 14.
05663_Conga 5290 Ultra_IM_YV_03220104.indd 4005663_Conga 5290 Ultra_IM_YV_03220104.indd 40 13/1/22 10:0713/1/22 10:07