CONGA ANIMAL
47
ENGLISH
only be scheduled through the remote control.
Note: Make sure the remote control is close to the robot when setting the time or scheduling
cleaning cycles.
Setting the scheduling time
- Press the button . Digits will start ashing.
- Use the direction buttons to set the time of the desired cleaning.
- Point the remote control to the robot and press the button to save the settings. The
robot will beep, letting you know the scheduled time has been conrmed.
Cancelling the scheduled time
- Point the remote control to the robot and press the button to cancel the scheduled
time. The display will show “12:00 a.m”, press the button to conrm. The robot will
beep, letting you know the scheduled time has been cancelled.
Tips:
- Before programming a function or changing time, make sure both the remote control and
the robot receive the order (by beeping).
- Once the cleaning is programmed, the robot will beep to conrm. If it does not beep,
settings have not been saved. Restart the robot and start again.
- If the lower switch is off, the schedule will be cancelled.
- When changing the remote control batteries, make sure you set the time again.
Cleaning modes
Automatic cleaning
- Press the button on the robot or the buttonn on the remote control to activate the
automatic cleaning mode from the Standby mode.
- Press the button on the robot or the button on the remote control for the robot to
return to Standby mode.
- Note: Place the robot near the cleaning area before starting cleaning.
Spot cleaning
- Press the button on the robot or the buttonn on the remote control to activate
the spot cleaning mode from the Standby mode. Robot will start cleaning automatically.
- Press the button on the robot or the button on the remote control for the robot to
return to Standby mode.
- Note: Place the robot near the cleaning area before starting cleaning.
Edge cleaning
Fig. 12
- Press the button on the remote control to activate the edge cleaning mode from the
Standby mode.
To Next Page
Loading...
