CONGA GRASSHOPPER 300
127
ENGLISH
E9 The mower is stuck 1. Position the mower in an area where
there are no obstacles.
2. If the error still appears, contact the
ocial Cecotec Technical Support
Service.
BP The battery protection
system has been
activated
1. Check the battery temperature. If it is
too high, wait until it cools down. If it
is too low, wait until the temperature
rises above 5 °C.
2. If the error still appears on the
display, contact the ocial Cecotec
Technical Support Service.
E11 The mower does not
receive a signal from
the boundary wire
1. When the mower is inside the
working area, check the colour of
the indicator light on the charging
station. If it is red, it means that
the boundary wire is not properly
connected to the charging station.
2. If the cable is properly connected,
but the indicator light is still red,
check that the cable is not broken.
3. If the error still appears on the
display, contact the ocial Cecotec
Technical Support Service.
E12 Battery problem Contact the ocial Cecotec Technical
Support Service to change the battery.
E13 Charging problem 1. Check that the charging head is
clean.
2. If the error still appears on the
display, contact the ocial Cecotec
Technical Support Service.
E14 The working area is too
large
1. Reduce the size of the working
area. Follow the instructions on this
manual.
2. If the error still appears on the
display, contact the ocial Cecotec
Technical Support Service.
To Next Page
Loading...