cecotec Conga Quick&Clean Vital - Page 45

45
ENGLISH
Spiral Mode Fig. 22
− The robot will carry out an intense cleaning of a specic area when this mode is activated.
It will start cleaning at a specic spot and will move outwards in a spiral motion (1 metre).
Then, it will return to the starting spot in an inwards spiral motion again.
− Once it has nished and returns to the starting spot, the robot will start cleaning in Auto
mode until it runs out of battery.
− Before using this mode, place it in the spot you wish to clean.
− Press the Spiral cleaning button on the remote control to activate this mode.
Edge Mode Fig. 23
− When this mode is selected, the robot will clean along walls and around furniture (e.g.,
table or chair legs).
− Press the edge cleaning button on the remote control.
Room Mode Fig. 24
- The robot will carry out a 30-minute cleaning cycle when this mode is selected.
- Press the Room mode button on the remote control.
- To ensure an ecient cleaning of the room, make sure the robot stays in the room.
Back home mode
Press the Back home button on the robot or on the remote control (with a house icon) to send
the robot to the charging base. The robot vacuum cleaner will continue vacuuming until it
reaches the charging base.
Manual mode
Press the direction buttons on the remote control to use the robot vacuum cleaner manually.
Power level function
Press the suction power level button on the remote control to control the robot suction power
during the cleaning process. There are 3 power levels: Turbo, Normal, and Eco. Fig. 25
Setting the time with the remote control
- Press the time setting button on the remote control. The digits will start ashing. Fig. 26
- Select the day of the week using the upwards and downwards direction buttons. To save
the selected day, press the Start/Pause button. Fig. 27
- Use the left and right direction buttons to set the minutes and hours. Use the upwards and
downwards arrow direction buttons to change the digits while they ash.
- Finally, press the Start/Pause button or the clock setting button. The robot vacuum cleaner
will beep when the time settings have been conrmed.
05791_Conga Quick&Clean Vital_IM_YV_01220803.indd 4505791_Conga Quick&Clean Vital_IM_YV_01220803.indd 45 3/8/22 13:253/8/22 13:25