cecotec CONGA ROCKSTAR 1600 TITANIUM - Error Codes; Understanding Error Codes; Technical Specifications; Product Specifications Details

CONGA ROCKSTAR 1600 TITANIUM
4948
ENGLISH ENGLISH
8. TECHNICAL SPECIFICATIONS
Product reference: 05762
Product: Rockstar 1600 Titanium
Voltage and frequency: 100-240 V ~ 50/60 Hz
29.6 V DC 2500 mAh 74 Wh battery
Motor rated power: 630 W
Brush rated power: 50 W
Charger rated output: 34.2 V DC 0.6 A
Made in China | Designed in Spain
9. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
dispose of the batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help to protect the environment.
10. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualied personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact Cecotec ocial Technical Support Service at +34 963 210 728.
11. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted or distributed by any means (electronic,
mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC
INNOVACIONES, S.L.
Insucient operating time
after charging the device.
(The battery life may vary
according to the room
temperature).
Insucient charge time.
The battery is old.
Fully charge the battery
following the instructions in
this manual.
Batteries are easily
recycled. Go to the closest
maintenance point and buy
new batteries.
7. ERROR CODES
Code Problem Cause
E1 The device turns o and does not
charge.
Short circuit
E2 The device does not charge. The charger’s voltage is below 36.3 V
E2 The device does not charge. The charger’s voltage is below 32.1 V
The device turns o. Low battery
E3 The device turns o and displays E3. The motor short-circuits when the
battery is low
E5 The device turns o and displays E5,. Main motor overload (second level)
E6 The device turns o and displays E6,. Main motor overload
E9 The device turns o and displays E9,. Temperature too high or low
E7 The device stops working or does not
turn on and shows E7.
Battery fault (rst level)
E8 The device turns o and displays E8,. NTC error (thermistor short circuit)
High-
eciency
lter
indicator
blinks
The device stops or does not switch
on. Fig. 14
High-eciency lter not installed
The lter set
logo ashes.
It works normally. Fig. 13 The dust tank or the inlet lter is
blocked
The brush
icon ashes
The long brush and motor stop
working. Fig. 15
Blocked long brush
Long brush full of hair