CREMMAET COMPACTCCINO BLACK / BLACK ROSE / WHITE ROSE / BLACK SILVER
44
ENGLISH
NOTE: the water may not come out at the ideal temperature during the rst few uses. This is
normal until the water pipes are lled with hot water and the machine reaches the desired
temperature.
- Press and hold the power switch for 3 seconds to switch o the coee machine.
Preparing an Espresso
1. Adjust the height of the coee spout and place a cup underneath. To adjust, simply slide
the spout up or down.
2. Press the Espresso icon to brew 1 espresso coee.
3. As the machine starts to operate, readjust the parameters if desired.
- During grinding (the control panel display shows “g” indicator light), press + or - to adjust
the amount of coee powder. During coee preparation (“mI” is displayed on the right-
hand side of the display), press + or - to adjust the number of millilitres of coee.
- Press on the double size icon to brew 2 cups of coee.
- Press EXIT to nish the operation.
Preparing an Americano
1. Adjust the height of the coee spout and place a cup underneath. To adjust, simply slide
the spout up or down.
2. Press the Americano icon to prepare an Americano coee.
3. As the machine starts to operate, readjust the parameters if desired.
- During grinding (the control panel display shows “g” indicator light), press + or - to adjust
the amount of coee powder. During coee preparation (“ml” is displayed on the right-
hand side of the control panel display), press + or - to adjust the amount of liquid coee.
Press on the double size icon to brew 2 cups of Americano coee.
- Press EXIT to nish the operation.
Installing the milk tank
1. The milk tank is tted to the bottom grid due to the shape of its base.
2. Open the milk tank lid and ll it to the desired level. Then, close the lid. Keep in mind that if
you put more milk than you are going to use, it will stay out of the refrigerator longer than
it should, which could spoil and cause unpleasant odours.
3. Fit the tube connecting the milk tank to the coee machine as shown in gure 1. To do this,
you must connect the tube on the milk tank lid to the inlet on the right side of the coee
spout.