EasyManua.ls Logo

cecotec CREMMAET COMPACTCCINO - Cleaning and Maintenance

cecotec CREMMAET COMPACTCCINO
156 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CREMMAET COMPACTCCINO BLACK / BLACK ROSE / WHITE ROSE / BLACK SILVER
47
ENGLISH
2. Double coee
When the Double size (x2) indicator light lights up, the double coee function is activated. In
this function, the appliance will prepare two coees at the same time.
The appliance will not prepare the second coee if the coee bean container runs out of coee
beans during the preparation of the rst coee.
3. Open panel
When the Open side cover indicator light lights up, the right side cover is open. Please, close it.
4. Empty water tank
When the Empty water tank indicator light lights up, the water tank is empty or low on water.
Please, ll it up.
5. Brew unit not installed
When the Brew unit indicator light lights up, the brew unit is not installed. Please, install it.
6. Coee waste tank
When the indicator light for accumulation of dregs in waste tank lights up, the waste tank is
not properly positioned or installed or it is full and needs to be emptied. Empty the waste tank
every 8 cups of coee.
7. Descaling
When the descaling indicator light lights up, the appliance needs to be descaled. Refer to the
“Descaling” subtitle in the “Cleaning and maintenance” section.
8. Warning of water shortage in the internal pipeline.
When the indicator light for water shortage in the internal pipeline lights up (Fig. 5), there is
water shortage in the internal pipeline of the coee machine. Make sure that there is water in
the tank and that it is properly installed. Press the Exit icon to restart the water pump and expel
the air accumulated in the internal pipes.
4. CLEANING AND MAINTENANCE
Cleaning/rinse
1. Adjust the height of the coee spout and place a cup underneath.
2. Press the Rinse icon every 3 seconds to start the cleaning/rinse. This function uses about
60 mI of water and ends automatically at the end of cleaning. It is used to remove possible
coee residues in the pipes.
Dismantling parts for cleaning
Fig. 4
1) Pull the water tank upwards by grasping it at the back and guide it out.
2) Pull the right side cover until it is removed.
3) Press where the blue arrow indicates at number 3 and pull the brew unit outwards for
cleaning.
4) The drip tray can be removed for cleaning by pulling it outwards. You will see the coee

Table of Contents

Related product manuals