cecotec Cumbia CREMMAET COMPACT - Coffee Bean Container and Grinder Cleaning; Ground Coffee Channel Cleaning; Dismantling Parts for Cleaning

CREMMAET COMPACT
45
ENGLISH
Coee bean
container/
grinder
Clean the coee bean
container weekly. Use a soft,
dry cloth to wipe oil/coee
grounds from the inside.
If there is too much oil inside
the bean container, it is
possible that there is too much
oil in the grinder.
Clean the grinder thoroughly in
case of grinding problems.
To clean the bean container and the
grinder, you can use a grinder cleaner for
coee machines: place the cleaner inside
the container and prepare an espresso
with the maximum amount of coee.
Then, clean the container by hand.
Ground coee
groove
Open the right panel, remove
the brewing unit and clean the
ground coee channel with a
soft cloth on a weekly basis.
Dismantling parts for cleaning
Fig. 15
1. Pull the water tank upwards and remove it.
2. Pull the right panel outwards.
3. Press where the blue arrow in gure 15 indicates and remove the processing unit.
4. Lift the drip tray slightly and remove it.
Fig. 16
1. Replace the water tank in the coee machine.
2. Push the processing unit along the groove until a snapping noise is heard, as shown in
gure 16.
3. Push the drip tray inwards into place.
Warning:
- When reinstalling the processor unit, a snapping noise will be heard; if you do not hear it,
disassemble the processor unit again and reinsert it.
- Make sure that the water tank is fully inserted. If this is not the case, push the water tank
down until it clicks into place.
6. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If a mechanical failure occurs in the appliance, please contact your supplier, authorised dealer
for repair or the ocial Cecotec Service Centre.