FREEGO WASH
38
ENGLISH
3. Press the power button to switch o the appliance.
Charging the appliance
Place the appliance on the charging base so as to insert it in the base connector.
When using the electric mop for the rst time, the battery may not be fully charged. Completely
charge the battery before rst use.
Auto-clean function
1. Make sure the water tank is lled. If not, ll it up.
2. Place the appliance on the self-cleaning base.
3. Press the auto-clean button to start auto-clean.
4. After the auto-clean cycle, the appliance will switch o automatically.
5. Remove, empty, and clean the clean water and waste-water tank after each auto-clean
cycle.
Note:
1. Before and after using the auto-clean function, empty the waste-water tank.
2. This mode is designed to prevent the wet rotary brush from producing bacteria or
unpleasant odours.
5. CLEANING AND MAINTENANCE
- Make sure the appliance is not plugged to a mains socket before cleaning it or carrying out
maintenance on it.
- Make sure the charging base is not plugged to a power outlet before cleaning it.
Cleaning the waste-water tank
When the waste-water tank is full, the light indicator on the base will light up and the appliance
will switch o. When this happens:
1. Once switched o, remove the tank as described in section “3.Product installation” and
empty it.
2. Was the waste-water tank.
3. After cleaning it, re-install the waste-water tank in the appliance. You can then resume
use.
Note:
After each use, it is recommended to clean the waste-water tank immediately.
If the water-level detection sensor is dirty, it can be cleaned with a cloth or rinsed with water
and then wiped with a cloth.
05862_FreeGo Wash_IM_LI.indd 3805862_FreeGo Wash_IM_LI.indd 38 7/3/23 10:217/3/23 10:21
To Next Page