What to do if my Cecotec Vacuum Cleaner cannot return to its charging base?
If your Cecotec Vacuum Cleaner is unable to return to its charging base, ensure that there are no obstructions blocking the path to the base. Clean the charging terminals on both the base and the robot using a clean, soft, dry cloth.
How to fix a bumper error on a Cecotec Vacuum Cleaner?
If your Cecotec Vacuum Cleaner displays a bumper error, check if the bumper is blocked. Press on both sides and the center of the bumper to unblock it.
What to do if I get a free-fall sensor error on my Cecotec Vacuum Cleaner?
If your Cecotec Vacuum Cleaner shows a free-fall sensor error, first check if the robot is on an uneven surface, if its wheels are off the ground, or if it's stuck in a dark place. Move it to a new location. If the issue persists, clean the free-fall sensor.
How to resolve a main brush error on a cecotec Conga Flash Connected Titanium?
If your Cecotec Vacuum Cleaner is showing a main brush error, remove and clean the main brush. Then, press the Start/Pause button to restart the robot vacuum cleaner.
How to fix omnidirectional wheel error on cecotec Conga Flash Connected Titanium?
If your Cecotec Vacuum Cleaner displays an omnidirectional wheel error, clean the omnidirectional wheel and press the Start/Pause button to restart the robot vacuum cleaner.
What to do if my Cecotec Vacuum Cleaner has a side brushes error?
If your Cecotec Vacuum Cleaner shows a side brushes error, clean the side brushes and press the Start/Pause button to restart the robot vacuum cleaner.
How to troubleshoot a suction motor error on a cecotec Conga Flash Connected Titanium?
If your Cecotec Vacuum Cleaner displays a suction motor error, remove and empty the tank. Also, remove the robot filter and shake off any dirt.
Identifies key parts like buttons, sensors, and brushes on the robot and charging base.
Details the power adapter, mixed tank, filters, side brushes, silicone brush, mop, and autoclean brush.
Essential safety precautions and checks before operating the robot vacuum cleaner.
Guides on placing the charging base against a wall and connecting it to power.
Instructions for installing side brushes and powering on the robot.
How to place the robot on the charging base and initiate operation.
Procedures for controlling the cleaning cycle of the robot vacuum cleaner.
Introduction to the different cleaning modes available for the robot.
Details on Auto, Scrubbing, Spiral, and Edge cleaning modes.
Covers Room mode, returning to base, manual control, power levels, and scheduling.
Instructions for cleaning and replacing high-efficiency, primary, and sponge filters.
Guides for cleaning sensors, silicone brush, side brushes, and their recommendations.
Information on battery longevity and the procedure for battery replacement.
Explains common robot error signals (beeps) and their corresponding solutions.
Details product specifications like model, voltage, capacity, and frequency.
Instructions for proper disposal of the product and battery according to regulations.
Contact details for technical support and warranty terms.
Legal information regarding the manual's content ownership.
Confirmation of compliance with relevant EU directives.
General| Model | Conga Flash Connected Titanium |
|---|---|
| Category | Vacuum Cleaner |
| Navigation | Smart Navigation |
| Suction Power | 2200 Pa |
| Mop | Yes |
| App Control | Yes |
| Voice Control | Yes |
| Battery Type | Lithium-Ion |
| Battery Life | Up to 120 minutes |
| Charging Time | 3-4 hours |
| Weight | 3.2 kg |
| Connectivity | Wi-Fi |
| Scheduled Cleaning | Yes |
| Auto Recharge | Yes |
| Color | Titanium |
| Type | Robot |
| Operating Modes | Auto, Edge, Manual |
| Filter | High Efficiency Filter |
| Noise Level | 64 dB |
| Virtual Walls | Yes |
To Next Page