cecotec Conga Flash Connected Titanium - Sensor and Brush Care; Battery Care and Replacement

46
ENGLISH
- Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
- To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig. 27
2. Insert the new battery with the battery label facing up. Fig. 28
3. Place the battery and the battery cover in its place and x properly the screws back
again.
6. TROUBLESHOOTING
Robot signal Cause Solution
Steady
red light
1 beep Omnidirectional wheel
error.
Clean the omnidirectional wheel and
press the Start/Pause button to restart
the robot vacuum cleaner.
2 beeps Side brushes error Clean the side brushes and press the
Start/Pause button to restart the robot
vacuum cleaner.
3 beeps Suction motor error Remove the tank and empty it.
Remove the robot lter and shake o
the dirt.
4 beeps Main brush error Remote and clean the main brush and
press the Start/Pause button to restart
the robot vacuum cleaner.
05794_Conga Flash Connected Titanium_IM_YV_01220902.indd 4605794_Conga Flash Connected Titanium_IM_YV_01220902.indd 46 24/8/22 8:0224/8/22 8:02