44
ENGLISH
Room mode. Fig. 23
- The robot will carry out a 30-minute cleaning cycle when this mode is selected.
- Select the room cleaning mode on the app.
- To ensure an ecient cleaning of the room, make sure the robot stays in the room.
Returning to the charging base
Press the Back home button on the robot or on the app (with a house icon) in order to send
the robot to the charging base. The robot vacuum cleaner will continue vacuuming until it
reaches the charging base.
Manual mode
Select the manual cleaning mode on the app to steer your robot vacuum cleaner manually.
Power level function
Select the power level on the app to control the robot suction power during cleaning
processes. There are 3 suction power levels: Turbo, Normal and Eco.
Cleaning scheduling
To make cleaning easier, the robot has a function that allows it to be programmed daily from
the app. According to the setting, the robot will automatically start cleaning in the selected
days at the desired time.
5. CLEANING AND MAINTENANCE
High-eciency lter. Fig. 24
- The high-eciency lter is designed with bres that help trap dust particles, dust
mites, pollen... It is very important to periodically clean the lter, to avoid these particles
from building up in the lter, causing eciency loss. It is convenient to carry out this
maintenance once a week.
- It is recommended to replace the high-eciency lter with a new one without exceeding
160 cleaning hours.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall o. The high-eciency lter cannot be washed.
Mesh primary lter and sponge lter
The ltering system is featured with a primary mesh lter and a sponge lter, located next to
the high-eciency lter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
05794_Conga Flash Connected Titanium_IM_YV_01220902.indd 4405794_Conga Flash Connected Titanium_IM_YV_01220902.indd 44 24/8/22 8:0224/8/22 8:02
To Next Page
Loading...
