cecotec FREEGO WASH - Cleaning the Floor Brush Assembly; Maintenance and Storage; Troubleshooting

FREEGO WASH
39
ENGLISH
Cleaning the oor brush assembly
1. Remove the rotary brush as described in section “3.Product installation”.
2. Use a dry cloth to clean the rotary brush area.
3. Clean the rotary brush with water.
4. After rinsing, place the rotary brush in position as described in section “3.Product
installation”.
Tips
When storing the appliance, make sure it is clean and dry by drying the tanks and rotary
brush in a well-ventilated place. This will prevent unpleasant odours caused by bacteria and
dampness.
Maintenance and storage
- Clean the waste-water tank, rotary brush, and its cover after each use.
- When the waste-water tank lls up during operation, empty it immediately so that it does
not aect the correct operation of the appliance. Fig. 4
- If the appliance is not going to be used for a long period of time, it is recommended to store
it as described above, in a cool and dry place. Do not store it under direct sunlight or in
damp places.
6. TROUBLESHOOTING
Problem Possible causes Possible solutions
The appliance
does not work.
1. Appliance not charged or
insucient voltage.
2. You did not press the power
button.
3. The rotary brush is blocked.
1. Charge the appliance.
2. Press the power button.
3. Clean the base and rotary
brush.
Lower suction
force.
1. The dirt inside the waste-water
tank has reached the maximum
capacity.
2. Rotary brush cover or waste-
water tank not properly installed.
3. There is tangled hair in the rotary
brush.
4. Not enough battery.
1. Clean the waste-water
tank.
2. Correctly install the brush
and cover.
3. Clean the rotary brush.
4. Charge the appliance
before turning it back on.
05862_FreeGo Wash_IM_LI.indd 3905862_FreeGo Wash_IM_LI.indd 39 7/3/23 10:217/3/23 10:21