CED CED7000 - Spy Mode; Stop Watch Mode; Countdown Mode

14.
SPY MODE:
DesignedtoallowtheusertoSPYonandtolearnfromothershooters.Whenthe“SpyMode”isse-
lected, the timer will switch automatically to “Instant Start” activation, and will turn up the sensitivity
to level 7. Additionally, the buzzer will not sound when the timer is activated. When in this mode,
theParfunctionisdisabledsincethereisnobeepsound,PressingtheSTARTbuttonwillsilentlyand
instantlyactivatethetimer,allowingtherecordingofshotsredinlocalproximityofthetimer.The
higher sensitivity level setting will enable the timer to pick up shots from a greater distance enabling
theusertorecord(monitor)anothershooter’sperformance.Iftheuserdecidesagreaterorlesserlevel
of sensitivity is needed, the setting can be manually changed by following the directions outlined in the
“SHOTDETECTIONMICROPHONE”sectionofthisinstructionmanual.
Thismodeisalsoperfectlysuitedfora2ndROonthestagetocreateabackuptimeonhisowntimer.
PLEASE NOTE: In this mode, the timer may also pick up other interferences as well due to the
heightenedsensitivitysettinglevel.Insomecaseswhereastageofremayinvolvelongdistances,the
timer may fail to register all shots due to the distance and sensitivity limitations.
STOP WATCH MODE:
Manytimesashooterwishestomeasureonastageofre,thetimingsequencesandmotionoftargets,
props, positions, as well as the transition times between various points of reference. Sometimes, it is
simply clocking the times of other shooters being watched. The CED7000 provides this function with
its built-in Stop Watch mode. When selected, the CED7000 timer acts as a Stop Watch. When in this
mode, both the microphone and buzzer on the timer are disconnected and will not function. To activate
theStopWatch,onceintheStopWatchmode,simplypresstheSTARTbutton.Theclockwilldisplay
itsrunningtimeintheTIMEareaofthedisplaywindow.ToeffectLaps,presstheREVIEWbutton
for each lap time desired. The Lap number will display in the SHOT area on the display window and
the lap time in the SPLIT area.
Tostopthetime,presstheSTARTagain.Tothenreviewthelaps,presstheREVIEWbutton,which
displayseachlap,itsnumberandtime.Toclearalltimesandlaps,presstheCLEARbuttononce.If
theSTARTbuttonispressedathirdtimewithoutclearingthedatastored,theinternalclockwillcon-
tinue running within the previous string displaying the current cumulative time from the original start
point. All lap data will be retained as part of the previous / current string until cleared.
COUNTDOWN MODE:
InCountdownMode,uponSTARTactivation,theCED7000Timerwillbeepandbegincountingdown
backwardfromanyselectedPARtimetozeroatwhichpoint,itwillbeepagain.ToactivateCount-
downmode,presstheMENUbutton,thenMODEandENTER.ScrolldownandhighlightCOUNT-
DOWN,pressENTERagain.CountdownModewillfunctionwithanydelaysetting,however,aPar
timeMUSTbeenteredtofunction.
PLEASE NOTE - The timer will NOT record shots or accept input data while operating in this
mode.
(This function is ideally suited for the National Shooting Complex “Sportsman’s Team Challenge
National Championship” or similar types of events. Ideal for controlling time-restricted match
stage walk through times)