CED CED7000T - Programmable Par Time Selection

10.
PROGRAMMABLE PAR TIME SELECTION:
AsinglePARtimecanbesetallowingtheusertocreateaxedintervaloftime.Selectionofa“Par
time”from0.60to999.99secondscanbeaccomplishedwiththeCED7000.(Note:Partimecanbe
settothe1/100thseclevel)SincetheSTARTbuzzerdurationbeepsfor0.50seconds,theminimum
PARtimeacceptedbythetimeris0.60seconds.ToselectaPARtime,pressMENU.Scrolldown
toselectthe“PAR”mode,highlightit,andpressENTERtoconrmit.SelectPar(forasinglePar
setting),CustomPar(forupto11PartimestobeactivatedoneafterthenexteachtimertheSTARTis
pressed), Auto Par (for up to 11 Par times and 11 delay times to be run automatically from one activa-
tion),orMultiplePar(torunupto5Partimesfromonesingleactivation)andpressENTERagain.
Pressthe“right”keytohighlighttherstcolumnandthenscrollupordowntoselectavaluefrom0
to 9 and then press the “right” key to highlight the second column and select a value for it and so on
untilallvevaluecolumnsareset.OncethedesiredPartimeisdisplayed,thenconrmthetimeset
bypressingENTER.
Toactivatethetimerandtheselected“Partime”,simplypresstheSTARTbutton.Asecond“stop”
beep will occur at the selected “Par time”. The timer will continue to record shots even after the se-
lectedPartimehaselapsed.Thisallowsaccuratereviewofalllateshotsandtheirexacttimered.
When in PAR time mode, the second beep will sound at the exact pre-set time for a 0.30 second
duration.
(Example – If a 5.00 second PAR time is selected, the PAR time is counted from the instant the
buzzer begins sounding (zero time) with the nal 0.30 second beep sounding precisely at 5.00
seconds, ending at 5.30 seconds total time)
TheCED7000timeralsofeaturestheabilitytobeprogrammedwithuptoelevenmultiplePARtimes
aswellasmultipledelayintervals.Additionally,eachPARtimeanddelayintervalcanbesettodiffer-
ent time lengths. When programming strings in Custom or Automatic Par, the user can clear values for
anystringshownonthedisplaybypressingtheCLEARbuttononce.IftheCLEARbuttonispressed
twice, it will erase all values set for the Par selection.
When in “Custom Par”, only the Par times are set for the number of desired strings up to a maximum
ofeleven.TheuserthenactivatesthetimerbypressingtheSTARTbutton,whichinturnrunseach
selectedParstringindividually.Theusermustre-presstheSTARTbuttontoactivatethenextstring,
but the timer moves forward to the next programmed Par each time it is activated until it completes all
strings programmed.
InAUTOMATICsetting,bothPARandDELAYtimesare selectedforanumberofstringsup toa
maximumofeleven.OncetheSTARTbuttonispressedandthetimeractivated,itwillrunALLstrings
programmed automatically until completed.
Example:
   String1PAR 3.00sec.
Delay 2.00 sec.
   String2PAR 5.00sec.
Delay 3.00 sec.
   String3PAR 6.50sec.