CED CED7000T - Basic Operation and Interface; Core Timer Functions

5.
BATTERY: (Continued….)
The timer continues to consume a trickle amount of power, even when turned off in order to keep the
internal clock (date / time) functioning and the memory storage intact. A newly
charged battery will provide over 25 hours of normal use and up to 33 days in stand-by or stored
capacity.
Optional Battery Pack:
AnoptionalBatteryPackisavailablethatwillprovideupto25hoursofextendedusefortheCED7000
Timer.Inadditiontoprovidingpowertothetimer,thebatterypackactuallychargesthetimer’sinter-
nalbatteryatthesametime.WhentheBatteryPackisconnectedtothebaseoftheCED7000Timer,
the battery symbol located on the LCD display will show an escalating signal, which informs the user
thattheinternalbatteryischarging.Whentheinternalbatteryisfullycharged,ORthe“AAA”batter-
iesinsidetheBatteryPackaredepletedoftheircharge,ORtheBatteryPackisdisconnectedfromthe
timer, the battery symbol will stop its escalating motion and display a solid battery level instead. If
theinternalbatteryisnotfullycharged,replacethetwo“AAA”batteriesinsidetheBatteryPackwith
fresh ones and re-connect it to the timer for continued charging use. When connected to the CED7000
Timer,theBatteryPackwillfullydepleteitschargingcapabilitieswithin2hours.Atsuchtime,itis
recommendedtodisconnecttheBatteryPackfromthetimer.NotallAlkalinebatterieshavethesame
output. Therefore, depending on the brand and rating, two “AAA” batteries may provide from 50% to
80%ofacompletechargetothetimer’sinternalbattery.
Example:EnergizerX92batteriesprovide80%charge.
OPERATION
BASIC FUNCTIONS:
TheCED7000canbeturnedonoroffbypressing(andholding)the“CLEAR”fora“onesecond”
duration. It is recommended that the Timer be turned off when not in use to conserve battery power.
TheCED7000isdesignedtoautomaticallyshut-offafterapproximatelyfteenminutesifnoinputis
received. The LCD will blank-out, but no loss of recorded input will occur. The user can re-activate
thetimerbypressing(andholdingforonesecond)the“CLEAR”button.
TheCED7000isautomaticallysetin“Comstock”Mode.TheInternationalIPSCRulebookdescribes
thisas:9.2.2“Comstock”:Unlimitedtimestopsonthelastshot,unlimitednumberofshotstobered,
stipulated number of hits per target to count for score.
TousetheCED7000,simplyturnontheTimerandpressoneofthetwo“START”buttonstoactivate
it.Abeepwillsound,(afterathreesecondxeddelay)whilesimultaneouslystartingtheclock.(note
–wheninuse,NOforwardtimeisshownonthedisplayuntilashotisregistered)
EachshotredwillregisterontheLCDdisplayandcontinuetodosouptoamaximumof999.99
seconds.TherearetwoSTARTbuttonsontheCED7000.Therstoneislocatedonthetopendofthe
timer,whiletheotherispositionedonthefrontcenterconsole.Uponcompletionofshooting,theLCD
displaywillindicatethe(rst)1stshotrecorded,thetotalshotsred/receivedandthecumulativetime
recorded. It will also display the Split time. The display also provides the day, month, year, and time,
unless this function is turned off.