CED CED7000T - Multi-Par Time Selection

11.
PROGRAMMABLE PAR TIME SELECTION: (Continued….)
The example above shows that three Par strings were programmed to function consecutively, each
with a different Par time and a different delay between each Par setting. The timer will begin after the
presetdelay,withtherstPartimeof3.0seconds,followedbya2seconddelay.EachnewPartime
stringwillbeginwiththebuzzerandclockcountingfromZEROandthebuzzerresoundingattheend
of selected Par time, followed by the given delay (if any is set) and then the starting of the next Par
stringandsoonuntilthelastPartimestringprogrammedhasbeencompleted.TheuserMUSTselect
bothaPar&DelaytimebeforepressingtheENTERtostorethedata.No Delay time should be set
for the last Par time selected.
PLEASE NOTE: A programmed function may be stopped (interrupted) at any time during the running
oftheprogrambypressingtheREVIEWbutton.Thetimerthenproceedstothenextstring.Ifthe
userwishestorepeattherststringagain,pressCLEARbuttontwice,whichreturnsthetimertothe
rststringPar/delay.Iftheuserthenwantstomoveforwardtothenextstring,withoutrunningthe
rststring,presstheSTARTbutton,followedbytheREVIEWbuttonBEFOREthecountdowndelay
reacheszero(thiswillnotworkinINSTANTdelay).Thiswillprogressthetimerforwardthroughthe
automaticParsequencesonebyone.
MULTI- PAR TIME SELECTION:
Thisinnovativefeaturegives the user a string ofupto ve possible Par beeps basedonone timer
activation only. The user can set Par times to the hundredth of a second for precise practice use. This
functionisexcellentfordryrepractice,draws,reloads,andtransitionalmovement.
Foruse,selectPARandthenscrolldownandselect“MULTI-PAR”,highlightit,andpressENTERto
conrmit.TheuserwillseeMulti-Par1with00.00totherightifit.Pressthe“right”keytohighlight
the desired column and then scroll up or down to select a value from 0 to 9 and then press “right” key
to highlight the next column and select a value for it and so on until all four value columns are set.
PressENTER toconrmthesetting andadvanceto thenextMulti-Parsetting tobeselected.The
timerallowsuptovePartimestobeselectedandenteredinMulti-Par.OnceALLofthedesiredPar
timeshavebeenselectedandentered,thenconrmthetimessetbypressingENTERagain.Dueto
thedurationoftheSTARTandPARbeeps,therstPar(inMulti-Par)cannotbesetforlessthan0.60
sec.,witheachsubsequentParbeingnotlessthan0.40seconds.
Example: Minimum allowed setting due to beep duration
P1= 01.00 00.60
P2= 01.25 00.40
P3= 01.20 00.40