Cedima CF-12.4 E-TR - Page 8

ENGLISH
• CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • Subject to modifications due to progressive development •
Contents of the operating manual
Joint Cutter CF-12.4 E-TR
CHAPTER 5 Maintenance and care
5.0 Maintenance and care 5-1
5.1 Cleaning 5-1
- Cleaning agents 5-1
5.2 How to clean 5-1
- Dry cleaning 5-1
- W
et cleaning 5-1
- Greasing, corrosion protection 5-1
5.3 Maintenance and care of the motor 5-1
5.4 Maintenance intervals table for the CEDIMA
®
joint cutter CF-12.4 E-TR 5-2
5.5 Safety checks of the electrical installations as per BGV 4 §
5, instructional paragraph 1 No. 2 5-3
Table A: Repeated controls of stationary electrical installations and equipment 5-3
Table B: Repeated controls of non-stationary electrical installations and equipment 5-3
5.6 Maintenance works 5-4
5.6.1 Adjusting the tension of the drive V
-belts 5-4
5.6.2 Changing the V-belts 5-5
5.7 Longer periods out of service / storage 5-6
5.8 Transporting the joint cutter CF-12.4 E-TR 5-6
CHAPTER 6 Return of machines / disposal
6.0 Return of machines / disposal 6-1
CHAPTER 7 Trouble shooting, what if . . .?
7.0 Faults/trouble shooting for the CF-12.4 E-TR joint cutter 7-1
7.1 Problems when starting (engine) 7-1
7.2 Problems when cutting (diamond saw blades) 7-2
CHAPTER 8 Appendix
8.0 Terms of warranty 8-1