Cedima CF 13.3 B - Page 39

39
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Maintenance and care
CF•13.3 B / CF•13.3 B-L
ENGLISH
6.6 Maintenance intervals for the CEDIMA® joint cutter CF•13.3 B / CF•13.3 B-L
before each start-up
after nishing work
after 1/2 operating hour
rst time after 10h
after 1 month or 20 h
weekly after 3
months or 50 h
after 6 months or 100 h
annually or 300 h
after 2 years
in case of faults
in case of damage
Entire machine
3 1 3 3 4***
Tool receptacle (anges and saw blade receptacle)
1, 2, 3 1 3, 5 4
Tool (diamond saw blade)
3, 6 1 3, 4, 6 ** 4
Operating elements (handles, crank handle, ...)
3 1 3, 4**, 5 4
Water system (hoses, tank, shut- o valve, ...)
3, 7 1 3 1, 3, 5 4***
V-ribbed belt
3 3, 5 5, 4** 4***
V-ribbed belt grooved pulleys
5**** 3, 4**, 5 4
Lubricating points
3 1, 2 5 4***
Threaded spindle
3 1, 2 1, 3, 4** 4***
Motor
3, 7, 8 8 * 8 * 8 * 8 * 8 * 8 4**
Parking brake
3 3, 5 4
Reachable connecting elements (screws,...)
5 3, 4**, 5 4***
Wheels
3 1 1, 3, 4**, 5 4***
h = operating hours *) Service more often in dusty environment **) Depending on load, condition ***) Depending on severity (extent) of damage ****) After mounting/repair Must be done by CEDIMA®
and/or personnel approved by CEDIMA®!
1 clean, drain 2 grease, lubricate, oil, corrosion protection 3 check (visual, function)
4 replace, exchange 5 Retighten, adjust, replace wear parts 6 Replace if required
7 Fluid levels check, replenish 8 Observe the corresponding operating manual
You will nd the description of the maintenance work in the following and corresponding chapters of this operating manual and in the operating manual of the engine! The table can be updated by CEDIMA® at any time (e.g. to comply with technical necessities and developments)! Please ask about it at CEDIMA®!