Cedima CF 13.3 B - Adjusting the Push Handle

18
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Preparation and operation
CF•13.3 B / CF•13.3 B-L
ENGLISH
4.3 Adjusting the push handle
Push handle mounted in position 2 Figure 4.9
4.4 Checking the V-ribbed belt tension
For the optimum check of the V-ribbed belt tension
use the measurement device recommended by the
V-ribbed belt manufacturer (tension to 70 Hz)!
If necessary, dismount the saw blade guard and the saw
blade mounted on the left (section 4.6.4)!
Push handle mounted in position 1 Figure 4.7
1.
3.
Observe the minimum insertion length of the push handle
Figure 4.8
2.
Remove plug from V-ribbed belt guard cover,
V-ribbed belt check through control opening Figure 4.10
approx. 5 mm