Cedima CF-22 E.800 - Maintenance and Care; Cleaning Agents

ENGLISH
24
• CEDIMA® • Technical Documentation • All rights reserved acc. to ISO 16016 • Changes serving technical progress reserved •
Maintenance and care -
Joint Cutter CF-22 E.800
DANGER
Risk of injury! Switch o the joint cutter during
cleaning and maintenance/repair work! Make
sure that the joint cutter will not start unintentionally or
roll away
The "Basic safety instructions" in Chapter3 of this operating
manual must be observed!
DANGER
Risk of injury due to electric short-circuit!
Disconnect the mains connection (pull out the
mains plug) before cleaning and maintenance
work!
The workplace for cleaning, maintenance, care and
any required repair work must be clean (dust-free) and
suitably equipped for the work!
• Place the joint cutter on a horizontal and stable
ground so that you have sucient space for cleaning,
maintenance, care and repair!
ATTENTION
Perform the maintenance work described in section5.5 in
the specied cycles (table5.7 "Maintenance intervals").
Check and, if necessary, replace or adjust wear parts that are
not subject to maintenance intervals!
Strictly adhere to maintenance and inspection intervals and
have the work done by CEDIMA®!
This will extend the service life of your joint cutter!
ATTENTION
Use original spare parts!
Only original spare parts can ensure the operational safety of
the joint cutter!
5.1 Cleaning
Clean the joint cutter after each use and
before any maintenance or repair!
5.1.1 Cleaning agents
ATTENTION
Never use aggressive detergents!
Aggressive cleaning liquids (e.g. solvents) as well as cleaning
with liquids with a temperature above 30°C is not permitted!
ATTENTION
Do not use high pressure or steam cleaners!
For reasons of safety and functionality, no water, detergent
or steam may enter the combustion engine, air lter,
electric components (e.g. electric motors, switch boxes,
plug connections, etc.)!
5.1.2 Notes about dry cleaning
• Remove dust and dirt with a slightly damp cloth!
• Use lint-free cleaning cloths!
• Remove tenacious deposits with a (non-abrasive) brush,
if required!
5.1.3 Notes about wet cleaning
• Cover/glue shut all vulnerable openings, housings, plug
connections, etc. before wet cleaning.
• Use a "soft" water beam and a non-abrasive brush to
remove dirt and residue!
• Be especially careful at critical spots (e.g. switches,
motor,...)!
The electric motor and all electrical components may not
come into contact with the water spray!
• Do not ush any bearings, otherwise there is a risk they
will dry out!
The joint cutter bearings are permanently lubricated!
• After cleaning, remove the covers/tapes completely
5.0 Maintenance and care