Cedima CF-22 E.800 - Page 29

ENGLISH
29
• CEDIMA® • Technical Documentation • All rights reserved acc. to ISO 16016 • Changes serving technical progress reserved •
Maintenance and care -
Joint Cutter CF-22 E.800
6. Install the V-belt guard, blade guard and cutting shaft
cover.
ATTENTION!
Do not use sharp or pointed objects to pull on the V-belts!
This will prevent damage to the V-belts which could lead to
their destruction!
Note
Turn the cutting shaft and motor V-belt pulley and move the
V-belts diagonally over the belt pulley grooves until all V-belts
lie parallel to one another!
ATTENTION!
Do not overstretch the V-belts (1.5% wear limit)!
Otherwise the joint cutter cutting shaft bearings and
motor bearings will be destroyed!
ATTENTION!
The new V-belts must be checked for correct tension after
10 hours of operation at the latest and retightened if
necessary!
5.8 Transporting the CF-22 E.800 joint
cutter
DANGER!
Risk of injury! The joint cutter is to be shut
down before transport and to be secured
against unexpected starting and rolling away!
Disconnect the mains, pull mains plug!
• Uncouple the external pressurized water hose and
completely drain the cooling and ushing system,
allowing it to run out!
• Dismount the diamond saw blade!
Do not transport the joint cutter with the diamond saw
blade mounted!
• Transport the joint cutter upright and horizontally!
• Swivel the front pointer (cantilever) upwards!
• Crank down the cutting shaft to the stop!
• Push in and lock the push handle!
ATTENTION!
The push handle is not designed to be transported by
crane!
• Ensure that all components of the joint cutter (on-board
tools, ...) are rmly attached!
• Lash the complete joint cutter to the push handle
receptacles and to the motor, cutting shaft and rocker!
• Disassemble the joint cutter into the intended (3) parts
(seesection4.1.1)!
After transporting and completely assembling the joint
cutter, check all screws and plug connections for tight t!
5.9 Longer periods of non-service/storage
• Observe the previously mentioned issues about
transport!
• Observe the maintenance intervals and perform
maintenance work!
• Release the V-belt!
• Approx. once monthly, turn (by hand) the cutting shaft
(engine) a few revolutions!
• Run the functions of the joint cutter approx. once
monthly!
• Unload the joint cutter wheels (e.g. with wood under the
frame)!
• Store the joint cutter in a dry and frost-free location.
Alsoprotect it against dust, strong sunlight and strong
vibrations and any other negative physical and chemical
impact!
• Check all assemblies and connecting elements for
correct (rm) seating!