KEY LOCK
The key lock activates, indicated by , if a stimulation program is active and
no buttons are pressed for 10 seconds.
1. To deactivate the keylock, press
once again.
indicates that the program is paused and no amplitude is generated. If
the stimulator is paused more than 5 minutes it turns off automatically to save
batteries.
MAINTENANCE
BATTERIES
The in the display shows when it is recommended to replace the bat-
teries. The batteries can still be used until the stimulation feels weaker or the
stimulator stops working.
1. Make sure the stimulator is switched off.
2. Remove the battery cover, by sliding it downwards and then lifting it
upwards.
3. Change the batteries to new ones (type AA 1,5V). Make sure the
polarisation placement (+ and -) is correct.
4. Replace the battery cover.
5. Dispose of the exhausted batteries according to local regulations.
CARE INSTRUCTIONS
Taking care of and cleaning CEFAR ACTIV X2 and CEFAR MYO X2 equipment is
simple, provided the following instructions are observed.
· Keep the stimulator and accessories in the original case when not in use.
· Never expose the stimulator to water. Wipe with a damp cloth if necessary.
· The cables are best preserved if left attached to the stimulator between
sessions.
· Do not jerk cabels or connections.
· The electrodes are re-moistened if necessary with a few drops of water and
kept air-tight (in a plastic bag) on protective paper when they are not in
use.
TROUBLE SHOOTING
The stimulation does not feel the same as usual
· Check that all settings are correct and make sure that the electrodes are
correctly placed.
· Slightly change the position of the electrodes.
The stimulation feels unpleasant
· The skin is irritated. For advice on skin care, see section
Precautionary
Measures.
To Next Page
Loading...
