12
• The electrodes are too old and need
to be replaced.
Cannot change program
Check if the code lock is activated.
Follow the instructions under the
Code Lock heading.
You should turn in your CEFAR IFC
for service once a year. Service should be
done by Cefar or one of Cefar’s distri-
butors.
Read the operating instructions prior to use.
Meets the requirements of MDD 93/42/EEC. Reported to SEMKO AB.
Patient body part, type BF – Body Floating.
Number of channels: 2 (simultaneous)
Stimulation forms: Interference
Premodulated
Constant current: Up to a resistance of 500 ohms.
Amplitude (strength of current): 0–50 mA in steps of 0.5 mA.
Wave form: Symmetric biphasic square pulse.
Carrier frequency: 4000 Hz
Treatment frequency: 1–150 Hz
Vector scan: 0–100 %
l r.m.s. max/channel: 50 mA
Power source: Two 1.5-V non-rechargeable AA batteries,
Two 1.2-V rechargeable AA batteries,
AC/DC Adapter 3V Friwo FW 7333M/03 (Cefar
article no. 1554). Note: Do not use the CEFAR
IFC with any other adapter.
Outer dimensions: 65 x 120 x 30 mm
Weight: about 160 g.
Environment for storage, Temperature 10°C–40°C.
use and transport: Humidity 30%–75%.
Air pressure 700 hPa–1,060 hPa.
0413
Warranty: The stimulator has a two-year warranty against defects, on condition that it is used correctly.
EXPLANATION OF SYMBOLS
TECHNICAL DATA
To Next Page
Loading...