cefar IFC - Custom Programming (P7)

Prg time 0–60 min.
(0 = endless)
Premodulated (PrE)
Treatment frequency 1
1–150 Hz
Treatment frequency 2
1–150 Hz
Treatment frequency 1
1–150 Hz
Treatment frequency 2
1–150 Hz
Interference (IFC)
Vector scan
0%, 40% or 100%
8
You program in program 7 yourself
using the diagram below:
1. Switch the stimulator on with
.
2. Press C. The stimulator goes automa-
tically into programming mode for
P7.
3. Follow the diagram below. Select all
settings for the
right channel using

and

Confirm all selections with C.
The diagram shows the lowest and
highest values you can set for each
parameter.
4. When you are done programming,
start stimulation with

for each
channel.
Note: The modulation time is always 6
seconds. If you do not want modulated
stimulation, set treatment frequency 1
and 2 the same.
PROGRAMMING (P7)
2470-200509_CEFAR_IFC_manual_inlaga_outline.indd 2005-09-14, 15:188