BC'
'
SAFETY INSTRUCTIONS
MALOPERATION OF THE INKREDIBLE 3D BIOPRINTER
INSTRUMENT CAN LEAD TO SEVERE AND IRREVERSIBLE
INJURIES IF THE SECURITY INSTRUCTIONS ARE NOT
FOLLOWED!
NOTE: In order to respond to the INKREDIBLE 3D Bioprinter and its relevant accessories
security requirements, the instrument has to be operated by trained personnel, which is aware
of the risks and dangers that can be induced to themselves, as well as for the staff being in
close relation with the INKREDIBLE 3D Bioprinter.
The staff being involved in the installation, or the maintenance of the system or a part of the
system, has to be qualified through an appropriate training.
GENERAL SAFETY INFORMATION
Use the instrument only for its intended purpose as described in the documentation. Do not
modify the instrument, sub-components or accessories.
Never reach into the instrument until all components of the instrument have
come to a complete stop. Moving parts can cause serious injuries.
Before cleaning, inspecting, adjusting, repairing or disassembling the
instrument or the dispensing units, stop the instrument and turn off the main
switch.
The INKREDIBLE Bioprinter is fitted with a 365nm (405nm option)
UV LED. DO NOT LOOK DIRECTLY AT THE LIGHT. ALWAYS
WEAR PROTECTIVE EQUIPMENT WHEN OPERATING THE
SYSTEM. ALWAYS WEAR THE INCLUDED SAFETY GLASSES.
Improper mounted pressurized air spouts, liquid spouts or cartridges can be
dangerous. Make sure all connections and connectors are mounted
according to instructions and all components are specified for use with the
intended pressure.
To Next Page
Loading...
