BZ'
'
-Turn the Control Knob Wheel [5] until the Ph 1 needle is right above the petri dish or well plate
well.
A little space of about 0.1mm should be visible between the print bed and the needle tip. You
can use a piece of paper to slide between the needle and the petri dish to measure the
distance. The paper should slide freely but there should not be more space than that.
-Once the correct distance has been selected, Press the Control Knob Wheel [5] once to exit
the Manual Calibration Z mode
-Scroll the Control Knob Wheel and select “Calibrate Z”
Your INKREDIBLE 3D Bioprinter is now calibrated and ready to print!
'
To Next Page
Loading...
