Gas cylinder installation
Gas cylinder removal
Prior to first use
20. When lighting the barbecue, the lid must always
be open.
21. Use heat-resistant BBQ gloves and sturdy long-
handled BBQ utensils when operating the barbecue.
22. Be prepared for possible accidents: make sure
you know the location of the first aid kit and fire extin-
guisher and are capable of using them.
Check the condition of the gas hose on regular basis.
Replace worn or damaged hose. Keep the gas hose
away from hot parts of the barbecue.
Make sure the gas hose is not twisted in a manner
preventing gas flow through the hose.
1. Check that all controllers of the barbecue are in the
OFF position.
2. Install the gas hose tightly to the low-pressure
regulator’s hose fitting and the other hose end to the
hose fitting on the barbecue. Use hose clamps for
tightening.
3. Attach the low-pressure regulator to the gas cylin-
der. Check the regulator connection to the gas cylin-
der by pulling the regulator strongly upwards.
4. Open gas supply from the low-pressure regulator
slowly, to stabilise the gas pressure.
1. Use the low-pressure regulator to turn o
the gas
flow.
2. Check that all controllers of the barbecue are in the
OFF position.
3. Detach the low-pressure regulator from the gas
cylinder.
Do not replace the gas cylinder near open flame or
embers.
Before first use of the barbecue, carry out full leak
testing in accordance with the instructions. Light the
barbecue and use all burners at MAX power for
approx. 5 minutes (but not longer) with the lid open.
After that, close the lid and continue using the barbe-
cue at MAX power for additional 2-3 minutes. Once
this is accomplished, the storage grease residues
have burned o
. Let the barbecue cool for about 15
minutes. Clean the grid and grilling plate by BBQ
cleaning brush. Oil the grid and grilling plate with
some cooking oil. Now the barbecue is ready for use.
TECHNICAL SPECIFICATIONS
BEFORE USING THE BARBECUE
Gas cylinder, gas hose, pressure regulator
The gas hose, low-pressure regulator and hose
clamps are not supplied by the manufacturer. These
components need to be purchased separately.
Acquire a LPG cylinder (min. 5 kg, max. 11 kg), low-
pressure regulator (30 mbar), and gas hose from your
dealer.
Note! The regulator connected to the cylinder may not
be adjustable in any way and must be marked with
the operating pressure 30 mbar.
The 30 mbar low-pressure regulators in the picture
are suitable for a gas barbecue, while the high-
pressure regulator on the right is intended for LPG
tools and must not be used with a gas barbecue.
The gas hose used must be a 10 mm LPG hose
approved for use in local country; the length may not
exceed 1.2 m.
3
2531-19
PIN CODE:2531CU-0080
Modell: Cello Ready 4i (A410)
Total power 17,2 kW
Main burners: 14 kW
Side burner: 3,2 kW
Gas consumption: 1252 g/h
Operating pressure: 30 mbar
Gas: Liquefied petroleum gas
(LPG) Category of use: I3 B/P
Main burner nozzle diameter: 0,93 mm
Side burner nozzle diameter: 0,89 mm
To Next Page
Loading...
