ASSEMBLY INSTRUCTIONS
Attention:
Please follow these assembly instructions step by step to assemble this upright bike.
1. Install the Front and Rear Stabilizers
Attach the front stabilizer (2) and rear stabilizer (3) onto the curve plates of main frame (1)
with carriage bolt (13), arc washer (14) and cap nut (15).
After assembly, the bike can be adjusted to slightly uneven ground by adjusting the height
of the foot caps at the rear stabilizer.
2.Install the Handlebar Post
Connect the sensor wire (16) from the main frame (1) to the upper sensor wire (21) from
the handlebar post (4). And then insert the handlebar post (4) to the main frame (1) and
secure with the screw (18) and arc washer (14).
5
To Next Page
Loading...
