Celsius CONDOR - Maintenance and Treatment

- 8 -
Maintenance and Treatment
1. Verify that all the bolts and nuts are locked properly and the turning parts should be turned
freely without damaged parts.
2. Clean the equipment with soap and slightly damp cloth only. Please do not use any solvent to
clean the equipment.
Malfunctions and Treatment
Malfunction Reason Treatment
Base is unstable.
1. Floor is not flat or there is small
object under the front or rear
stabilizer.
2. The rear stabilizer end caps have
not been leveled when
assembling.
1. Remove the object.
2. Adjust the rear stabilizer end caps.
Handlebar is shaking.
The bolts and saddle post knob are
loose.
Tighten the Bolts and saddle post
knob.
Loud noise from the
moving parts.
The interval of the parts is improper
tighten.
Open the covers to adjust.
No resistance when
riding the upright
bike.
1. The interval of the magnetic
resistance increases.
2. Tension controller is damaged.
3. Running belt slips.
4. The bearing set is damaged.
1. Open the covers to adjust.
2. Change the tension controller.
3. Open the covers to adjust.
4. Change the bearing set.