Cely PS-50 Series - Setting the Secondary Unit; Setting Time for Automatic-Off Mode (Sleep); Setting High or Low Speed

Series PS-50/60
49-MCEPS56EN03 USER´S MANUAL
4
7.6. SETTING THE SECONDARY UNIT
After entering Configuration mode, the display will show “F0 CAL”. Press four times and the display will
show “F4 unt”. Press
to enter, then press to change the secondary weighing unit. Press and
simultaneously to exit.
7.7. SETTING TIME FOR AUTOMATIC-OFF MODE (SLEEP)
In Configuration mode, the display will show “F0 CAL”. Press five times and the display will show “F5
oFF”. Press
to enter, then press to change the time until entering in sleep mode (options: “oN”, 3, 5,
10 and 20 minutes). Press
and simultaneously to exit.
7.8. SETTING HIGH OR LOW SPEED
After entering Configuration mode, the display will show “F0 CAL”. Press six times and the display will
show “F6 FLT”. Press
to enter, then press to change the average time before the filter starts
operating, options: 1,2,3,4. If the value is high, the weight is more precise. Press
and
simultaneously to exit.